3D Printing with the Raspberry Pi: Guides, Reviews and Practical Know-How

The Raspberry Pi and a 3D printer are a natural team: the Pi handles the web interface, the camera monitoring and the link into Home Assistant — and in return the printer produces cases, HAT brackets and mounting plates for your Pi projects. This is where we collect all of it: setup guides, hardware in long-term testing and the basics if you are just getting started.

Tested here, not copied from spec sheets Always with a Raspberry Pi angle Step-by-step, built to follow along

🧩Reviews & buying advice

What we actually run here — with measurements, long-term experience and a clear verdict instead of a rewritten spec sheet.

Review Elegoo Neptune 4 Plus review Klipper out of the box and a 320 × 320 × 385 mm build volume: what a large-format printer actually buys you as a maker — from homelab rack panels to hooking it into Home Assistant. Read the review → How-to Neptune 4: setting the Z-offset — why the first print fails The first print after power-on splits, the second runs clean: the nozzle sits around 1.8 mm too high and the correction is missing. Measure with paper, put the value in the start G-code, probe the bed finely — with console transcripts. Read the guide → How-to BTT Eddy Duo on the Neptune 4 Plus: bed mesh in 13 seconds Retrofit the eddy current probe without reflashing the printer: matching firmware, bracket, paper-test calibration – and a zero point without a Z offset. Read the article → Buying guide 3D printer filament guide: which filament for what? PLA, PETG, TPU or ASA? Which material works for Pi cases, where the temperature limits are and how to store and dry your spools properly. Read the guide → How-to Filament storage: a DIY dry box for 8 euros per spool 4-litre food container, printed silica gel insert and mini hygrometer: a sealed storage box that keeps filament dry and shows you the state of every spool from the outside. Read the guide → How-to Neptune 4 Plus printable upgrades: 5 useful parts the printer makes itself Print bed corners, tool tray, HexScraper, hanging storage box and a filament dry box: the first useful prints for the Neptune 4 Plus with profiles, print times and photos. Read the article → How-to DIY 3D printer table: a stable cabinet with storage A closed cabinet cut from one 22 mm chipboard sheet at the hardware store, no wobble in the bed axis — with cutting list, screw layout, material costs and a downloadable build plan. Read the guide →

📚Every 3D printing article at a glance

Every article in this section, sorted alphabetically – including the ones without a card above.